# Caulking, Sealing and Waterproofing | Sharp's Painting

Caulking, sealing and waterproofing means closing the gaps and joints that let water in behind a house, and Sharp's Painting does it on homes in Huntington Beach and coastal Orange County. Robert Sharp seals trim edges, window and door frames, siding seams, and stucco cracks. Old dried caulk gets cut out rather than covered over, because a fresh bead laid on top of a failed joint never bonds and it hides water that is still getting past. Sealing happens during prep, after pressure washing, scraping, sanding, and replacing rotted wood and fascia, so the caulk beds into clean surfaces ahead of primer and the sprayed and back rolled finish. Salt air, sun, and the overnight marine layer keep working those joints. Robert is a licensed C-33 painting contractor, license 1048840, bonded and insured, with 27 years in the trade. He runs his own crew, no subcontractors, and stays on site. Estimates are free and you owe nothing until the job is done and you are satisfied.

Provided by Sharp's Painting in Huntington Beach, CA. Call (714) 610-5880 for a free estimate.

## Why choose us
- Water stays out of the walls because the gaps, joints, and penetrations that let it in get sealed the right way
- Caulking goes on before paint, so every joint is clean and prepped and the finish lasts through coastal weather
- Stucco cracks and open seams get patched and sealed before they turn into water damage inside the wall
- Robert handles the sealing work himself on site, and you pay nothing until it is done and you approve it

## How it works
1. **Walk the home and find every gap**: Robert goes around the outside with you and marks the trim edges, window and door frames, siding seams, stucco cracks, and roof penetrations where water can get in.
2. **Clean and prep the joints**: Old failed caulk gets cut out, loose material is scraped back, and the surfaces are pressure washed so the new sealant bonds to clean stucco and wood instead of grime.
3. **Seal, caulk, and prime**: Fresh caulk is packed into each joint and crack, wall penetrations are sealed, and bare spots are primed so the paint has a tight sealed surface to grip.
4. **Check it before paint**: Robert goes back over every sealed joint to make sure nothing was missed, then the paint goes on and you look it over before the job is called finished.

## FAQ
### Why does caulking need to happen before you paint?
Paint on its own will not seal an open joint, and if you paint over a gap the water still gets behind it. Caulk goes in first so the joint is closed and clean, then the paint covers a surface that is already sealed. Doing it in that order is why the work holds up near the coast.

### Which spots on my house actually let water in?
The usual ones are the seams around windows and doors, the edges of trim and fascia, joints where siding or stucco meet, and any spot where a pipe, vent, or light comes through the wall. Stucco cracks are a big one this close to the beach. Robert checks all of these on the walkthrough.

### Does the salt air and marine layer really make this worse?
Yes. The damp marine layer sits on the house overnight and the salt air is hard on every finish, so any open gap gets worked on constantly. Old caulk dries out and pulls away, and once a joint opens up the moisture keeps pushing in. Sealing those spots is what keeps a coastal home dry.

### Are you licensed, and when do I pay?
Sharp's Painting holds California C-33 license number 1048840 and is bonded and insured. Robert has 27 years of painting experience and runs his own crew with no subcontractors. You owe nothing until the work is done and you have looked it over, and the estimate is always free.

### Do you cut out the old cracked caulk or just seal over it?
The old failed caulk comes out first. Sealing over a split bead does not hold, because water is already tracking behind it and fresh sealant will not bond to a dirty joint. On Huntington Beach exteriors Robert cuts and scrapes the dead material out, the joint gets pressure washed and left to dry, and then the new bead goes in and gets primed before any paint touches it. Robert is on site for that prep himself.

## Contact
Phone (714) 610-5880 · https://www.sharpspaintingco.com/contact